I have 64 bit version of Windows, also my program NX10 is 64 bit version.
Do not install 64 bit version of the application on 32 bit version of Windows.
If you have a 32 bit version of Windows then ensure to install the 32 bit version of that application to check if that helps. Is the issue specific to this installation? Please answer these questions to get more clarity on this issue?ĭid you make any changes to the pc prior to this issue? a message popped out about the UI mode not supported. I have tried changing the compatibility to Windows 8, the same thing happened. How satisfied are you with this response? Thanks for your feedback, it helps us improve the site. Great! Thanks for marking this as the answer. Let us know how it goes, we’ll be glad to assist you further. Once this is done, restart the computer and check if the issue persists. Right-click on the setup file and click on ‘ Properties’.Ĭlick on the ‘ Compatibility’ tab and check the box ‘ Run this program in compatibility mode for’ and select Windows 8/8.1 operating system from the drop down menu and proceed with the installation.
Follow these steps to install the drivers in compatibility mode and check if that helps. Compatibility mode runs the program using settings from a previous version of Windows. I suggest you to install NX10 in compatibility mode and check if it helps. What is the make and model of the computer?ĭid you try installing the application in compatibility mode? Please reply to these questions, to understand the issue better: Thank you for posting your query in Microsoft Community.
However we are affiliated not all but with some software companies and some posts may contain affiliate links.We are not responsible for any data loss / business loss, device corruption or any other type of loss due to the use of any software or command mentioned in our posts. We disclaim any ownership, right of such third party products or copyrighted material unless otherwise specified. Any brand name, trademark, image used on this website are for reference only. Is there any way to reduce the timeout on the Windows Installer?Windows 10 (v1703). I cannot remove the registry entry that matches the component ID as that stops the Sage program functioning properly. The component is MSCOMCTL, a system file.Totally confused as to what to do. Installer User Interface Mode Not Supported Informatica LinuxĪfter pressing cancel and waiting it eventually gives an error “Windows Install Server Not Responding”, but that then allows the VB6 program to continue.Looking at the administration logs, MSIExec is showing two errors (1001, 1004) trying to access a component from a different program (Sage Line 50). I can cancel it, but it takes literally over 30 minutes to close the installer popup before my program is then allowed to run. I have an issue where Windows Installer pops up whenever I run an old VB6 program. Installer User Interface Mode Not Supported Informatica Linux.Hi I am getting following error, due to “IIS 6 Management Compatibility” is not installed on my machine.